1. Laser Dust Collector in Stock Filter Bag surface is not enough

In the work of Laser Dust Collector in Stock, if the discharge is exceeded and the running pressure of the dust collector is too lower than the design, it is likely that the initial powder of the surface of the filter bag is insufficient. The cleaning cycle of the filter bag is too short, the pressure of blowing the air is too high, and the loading of dust is reduced.

Laser Dust Collector in Stock In operation, if too high filtering speed, the exhaust rate of dust will increase, and the high filtration air speed will crush the initial powder layer, and the dust shock filter bag will cause excessive wear. If this is this Time -to -clean filter bags are too high to cause the fabric loose fabrics of the filter bag, which will cause the dust collector to discharge exceeding the standard.

2. Filter bag is broken

If the filter bag is worn, burned, and corrosion in the Laser Dust Collector in Stock, the dust collector emissions dust exceeds the standard. The cause of the burning of the filter bag of the dust collector is mainly due to the high temperature of the exhaust gas. If the long -term waste gas temperature of the dust collector exceeds the working conditions of the filter bag, it is easy to cause the filter bag to hardly shrink, or melt to produce holes, and choose to replace the replacement. It is particularly important when filtering. The cause of the corrosion of the filter bag is that the gel water in the airflow can also cause the filter bag to block. When the initial dust layer on the surface of the filter bag is due to moisture, the dust will be condensed and knotted after drying, which will cause the filter bag to go to go to the formula of the filter bag. Elasticity, if the pulse washing the filter bag under this condition, the damage of the filter bag will be accelerated.

laser dust collector in stock https://www.kaisenfilter.com/KSDC-6102-Laser-Dust-Collector.html