What Should You Pay Attention To When Operating Rubber Extruder?

0
6K

The reasons for the abnormal noise during the operation of the rubber extruder are as follows:

1. In the reducer, it may be caused by bearing damage or poor lubrication, or it may be caused by gear wear, improper installation and adjustment, or poor meshing. It can be achieved by replacing bearings, lubricating, replacing gears, or adjusting gear meshing conditions to solve.

2. If the noise is a sharp scraping sound, we should consider the position deviation of the cylinder, so that it is possible to scrape off the shaft head and the drive shaft sleeve. This problem can be solved by adjusting the cylinder.

3. If the cylinder makes noise, it may be that the screw bends and sweeps the cavity, or the temperature is set too low so that the friction of solid particles is too large. It can be handled by straightening the screw or increasing the set temperature.

Pesquisar
Categorias
Leia Mais
Jogos
Acquista Currency POE 2: Guida Completa per Comprare POE 2 Currency in Modo Sicuro e Veloce
Acquista Currency POE 2: Guida Completa per Comprare POE 2 Currency in Modo Sicuro e Veloce Se...
Por Casey 2025-04-21 20:45:43 0 886
Jogos
Buy FC 25 Coins Quick Delivery: Your Ultimate Guide to the Best FIFA 25 Coins Store Online
Buy FC 25 Coins Quick Delivery: Your Ultimate Guide to the Best FIFA 25 Coins Store Online In...
Por Casey 2024-11-16 21:14:35 0 2K
Início
Finding the Best Trane Dealer in Las Vegas: What You Need to Know
Las Vegas is known for its intense desert heat, where summer temperatures often exceed 100°F....
Por Infinityheatingandcooling 2025-03-24 13:56:58 0 2K
Outro
Why Soft Jaws Are Essential in Precision Machining
In the world of precision machining, accuracy often depends on more than just advanced tooling or...
Por usshoptools 2025-07-17 15:21:05 0 462
Networking
AI in Insurance Market: Trends, Growth Drivers, and Future Prospects 2024-2032
The insurance industry, traditionally seen as conservative and slow to adopt new technologies, is...
Por Daharwal_1990 2024-07-22 08:40:56 0 5K